Dunk Tank Setup Instructions

STEP 1. Disconnect trailer safety chain and electrical tow plug from vehicle.
STEP 2. Unhook Dunk Tank from Vehicle.
STEP 3. Place Dunk Tank on a flat, level surface clear of all debris.
STEP 4. Pull the tongue safety pin and rotate (pull) tongue fully to the side and install safety pin.
STEP 5. Stand dunk tank to its upright position.
STEP 6. Close tank drain.
STEP 7. Begin filling with water. A minimum of one (1) inch above the top of the window.
STEP 8. Remove the brace bar that secures the target frame to the dunk tank.
STEP 9. Pull release pin and open the target frame.
STEP 10. Lock target frame to tongue with detent pin.
STEP 11. Latch dunking board to trigger latch.
STEP 12. A responsible adult is required in attendance at all times.
LET THE FUN BEGIN!

Safety Rules

A RESPONSIBLE ADULT IS REQUIRED IN ATTENDANCE AT ALL TIMES
Keep Dunk tank away from all electrical sources.

Place Dunk Tank on a flat, level surface clear of all debris.
Check Tank, Tank Steps, window mounting, dunking board, and trailer frame for sharp edges or damage which could result in personal injury.
DO NOT CLIMB ON DUNK TANK BEFORE FILLING WITH WATER!
Maintain water level to at least one (1) inch above the window at all times.
No one allowed in the Tank less than 54 inches tall.
Only one person at a time allowed on the dunking board or in the Tank.
Always wear water socks or tennis shoes to keep from slipping.
Water must be drained when Tank is unattended. NO EXCEPTIONS!
Only use “soft” Soft Balls! Under no circumstances should a baseball, standard soft ball or any other hard object be thrown at the target.
Never stand on the dunking board.
Sit forward and keep hands on knees while seated on the dunking board.
Do Not jump up after being dunked.
Do Not hit target with your hand.
Do Not operate Dunk Tank in any type electrical storm.